** Boring Holes in Cork [8]
The following hints will be found useful when boring holes in
cork. In boring through rubber corks, a little household ammonia
applied to the bit enables one to make a much smoother hole and
one that is nearly the same size at both openings. The common
cork, if rolled under the shoe sole, can be punctured easily and a
hole can be bored straighter. The boring is made easier by boiling
the cork, and this operation insures a hole that will he the
desired size and remain the size of the punch or bit used.
** Self-Lighting Arc Searchlight [9]
A practical and easily constructed self-lighting arc searchlight
can be made in the following manner: Procure a large can, about 6
in. in diameter, and cut three holes in its side about 2 in. from
the back end, and in the positions shown in the sketch. Two of the
holes are cut large enough to hold a short section of a garden
hose tightly, as shown at AA. A piece of porcelain tube, B, used
for insulation, is fitted tightly in the third hole. The hose
insulation A should hold the carbon F rigidly, while the carbon E
should rest loosely in its insulation.
Pages:
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33