When the desired reduction has taken place, stop the action at
once by immersing the print in a 10-per-cent solution of borax.
The prints may be allowed to remain in this last solution until
they are finished. A good final washing completes the process.
This washing must be thorough and a sponge or a tuft of cotton
used to clean the surface of the print.
With a little practice, this method of saving prints that are too
dark becomes easy and certain. The prints are lightened and at the
same time improved in tone, being made blue-black with a delicate
and pleasing quality that will tempt you to purposely overexpose
some of your prints in order to tone them by this method for
certain effects. The process is particularly valuable to the
worker in large sizes, as it provides a means of making quite a
saving of paper that would otherwise be thrown away.
** An Ironing-Board Stand [17]
An ordinary ironing board is cut square on the large end and a
slot cut 1-1/2 in. wide and 4 in. long to admit the angle support.
The support is placed against the table and the board
[Illustration: Stand Attached to Table]
is pressed down against the outer notch which jams against the
table, thus holding the board rigid and in such a position as to
give free access for ironing dresses, etc.
Pages:
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51