A 3/4-in. hole is cut near the edge of one of
the saucers for the exhaust. If it is desired to carry the exhaust
beyond the casing, a thin pipe can be inserted 1/4 in. into the
hole. Holes are drilled through the pipe on both inside and
outside of the casing, and pins inserted, as shown in Fig. 5.
Solder is run around the outside pin to keep the steam from
escaping. At the lowest point of the saucer or casing a 1/8-in.
hole is drilled to run off the water. A wood plug will answer for
a stopcock.
If metal dishes, shaped from thick material with a good coating of
tin, can be procured, it will be much easier to construct the
casing than if enameled ware is used. The holes can be easily
drilled and the parts fitted together closely. All seams and
surfaces around fittings can be soldered.
Nozzles are made of two stopcocks having a 1/8-in. hole. These are
connected to a 3/8-in. supply pipe. The nozzles should be set at
an angle of 20 deg. with the face of the disk. The nozzle or
stopcock will give better results if the discharge end is filed
parallel to the face of the disk when at an angle of 20 deg.
Pages:
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60