5, is made of wire, aluminum being
preferable for this purpose, although copper or steel will do.
Make the wire 4-1/2 in. long and make a loop, D, 1/2 in. from the
lower end. Solder to the short end a piece of brass, E, of such
weight that it will exactly balance the weight of the hand. This
is slipped on the pivot, and the whole thing is again placed in
position in the support. If the pointer is correctly balanced it
should take the position shown in Fig. 1, but if it is not exactly
right a little filing will bring it near enough so that it may be
corrected by the adjusting-screw.
Next make a brass frame as shown in Fig. 6. This may be made of
wood, although brass is better, as the eddy currents set up in a
conductor surrounding a magnet tend to stop oscillation of the
magnet. (The core is magnetized when a current flows through the
instrument.) The brass frame is wound with magnet wire, the size
depending on the number of amperes to be measured. Mine is wound
with two layers of No. 14 wire, 10 turns to each layer, and is
about right for ordinary experimental purposes. The ends of the
wire are fastened to the binding posts B and C, Fig.
Pages:
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129